During the use of Special cutting fluid for aluminum products, safety matters are crucial and cannot be ignored. The following are some safety matters that need to be paid attention to when using Special cutting fluid for aluminum products:
First, operators should wear protective equipment. Cutting fluid may splash during use, causing damage to personnel's eyes and skin. Therefore, operators must wear protective glasses, gloves and protective clothing to ensure that splashes of cutting fluid do not come into contact with exposed skin or eyes.
Secondly, ensure the environmental safety of cutting fluid storage and use. Cutting fluid should be stored in a well-ventilated area away from fire and heat sources. Avoid direct sunlight to prevent the cutting fluid from deteriorating due to high temperature or producing harmful gases. At the same time, cutting fluid containers should be clearly marked, including name, concentration, production date and other information, to facilitate identification and management.
Furthermore, regularly check the equipment using cutting fluid. Ensure that the cutting fluid supply system, circulation system and filtration system are in good condition to avoid cutting fluid leakage or contamination. Aging equipment or pipelines should be replaced or repaired in time to ensure the normal use of cutting fluid.
In addition, the concentration control of cutting fluid is also an important part of safe use. Too high a concentration may cause unstable cutting fluid performance and even produce harmful gases; while too low a concentration may affect the cutting effect and increase equipment wear. Therefore, operators should strictly follow the requirements of the product instructions and control the concentration of cutting fluid within an appropriate range.
Finally, operators should follow relevant safety operating procedures when using cutting fluids. For example, it is prohibited to smoke or work with open flames near cutting fluid to prevent fire. At the same time, after the operation is completed, the cutting fluid supply valve should be closed in time and the site should be cleaned to ensure the safety and hygiene of the work area.
In summary, there are many safety matters that need to be paid attention to when using Special cutting fluid for aluminum products. Operators should improve safety awareness, strictly abide by operating procedures, ensure the safe use of cutting fluids, and ensure the smooth progress of the production process.
