Special cutting fluid for aluminum productsIn the process of mechanical processing, its odor control and working environment friendliness are crucial aspects, which are directly related to the work experience and health of operators.
The odor of cutting fluid often comes from the various chemical additives it contains. Some base oils and additives may release volatile organic compounds (VOCs) due to high temperature, high pressure and chemical reaction with aluminum chips during processing, resulting in pungent odor. In order to control the odor, it is necessary to carefully select low-odor and low-volatility raw materials in the formulation research and development stage of cutting fluid. For example, high-quality synthetic ester base oil is used instead of traditional mineral oil. Synthetic ester has good lubricity and relatively mild odor. At the same time, optimize the type and amount of additives, avoid using additives such as sulfur-containing and chlorine-containing additives that are prone to produce irritating odors, and use environmentally friendly rust inhibitors, lubricants, etc. to reduce the generation of odor from the source.
During use, the maintenance and management of cutting fluid also has an important impact on odor control. If the cutting fluid is not replaced for a long time or is contaminated, the growth of microorganisms will cause the cutting fluid to deteriorate and produce an unpleasant odor. Therefore, it is necessary to regularly monitor the concentration, pH value and microbial content of the cutting fluid, add bactericides and filter and purify in time to keep the cutting fluid clean and stable in performance, and prevent the odor problem from being aggravated by deterioration. In addition, by optimizing the cutting fluid supply system and adopting precise spraying or dripping methods to reduce the atomization and splashing of the cutting fluid, the diffusion of odor in the air can also be reduced.
The friendliness of the working environment is also reflected in the impact of the cutting fluid on the health of the operator. Low-odor cutting fluid can reduce health problems such as respiratory discomfort caused by inhalation of irritating odors. At the same time, some environmentally friendly special cutting fluid for aluminum products have good skin compatibility and are not easy to cause skin allergies, redness and swelling. This requires that the cutting fluid should fully consider the safety of the human body when designing the formula, avoid the use of toxic and harmful chemicals, and conduct strict biological toxicity tests.
In the long run, the odor control and working environment friendliness of special cutting fluid for aluminum products are in line with the development trend of green manufacturing. With the increasingly stringent environmental regulations and the increasing attention paid by enterprises to the health of employees, the development and use of low-odor, environmentally friendly cutting fluids will help enterprises improve production efficiency and reduce employee turnover, while also laying the foundation for the sustainable development of the entire industry. Through continuous technological innovation and strict production management, Special cutting fluid for aluminum products will make greater progress in odor control and work environment friendliness, creating better production conditions for the aluminum processing industry.
